Waterpik Technologies Outdoor Shower AquaScape User Manual

InSTAllATIon  
lImITed lIFeTIme WArrAnTy  
FrAnçAIS  
No tools needed.  
Water Pik, Inc. warrants to the original purchaser of this product that it is  
free from defects in material and workmanship for as long as the original  
purchaser owns this product. Water Pik, Inc. will at our election, repair  
or replace any part of the product which in our opinion is defective, pro-  
vided that the product has not been abused, misused, altered or dam-  
aged after purchase. (This includes damage due to use of tools or harsh  
chemicals.) In the event an item has been discontinued we will replace  
with what we deem to be the closest product. Water Pik, Inc. is not  
responsible for labor charges, installation, or other consequential cost.  
The responsibility of Water Pik, Inc. shall not exceed the original pur-  
chase price of the product. This warranty gives you specific legal rights.  
Save your receipt as proof of purchase is required for warranty action.  
Remove old showerhead. Clean pipe threads thoroughly. Hand tighten  
pivot ball to pipe. To align unit to shower pipe, loosen nut, reposition  
shower head. Re-tighten nut.  
réglAge du déBIT  
®
Les pommes de douche Waterpik sont équipées d’un régulateur  
®
Waterpik AquaScape  
®
OptiFLOW qui limite le débit d’eau maximal à 2,5 gallons par minute à  
Total Body Showerhead  
80 lb/po_, conformément aux exigences de la loi fédérale américaine.  
Dans les régions où la pression de l’eau est très  
faible, causant un débit d’eau médiocre dans la  
pomme de douche, il est possible de retirer le  
régulateur afin d’augmenter le débit d’eau.  
Pour retirer le régulateur, dévisser la grille  
du filtre en la tournant dans le sens horaire.  
Ôter le régulateur avec une pince à bec  
Pomme de douche  
®
Waterpik AquaScape  
- Aspersion totale  
Cabezal de ducha  
®
Waterpik AquaScape  
Pipe  
Cubre todo el cuerpo  
effilé et réinstaller la grille du filtre.  
joint  
régulateur  
de débit  
Pivot Ball  
Nut  
oPerATIon  
tamis de  
filtration  
The 9” AquaScape™ Total Body Shower has two spray settings, as  
opposed to the one spray setting on the 6” model. To change settings  
from either the full-body spray or the concentrated power spray, push  
the spray change button on the back of the showerhead so it extends to  
the opposite side of its current position.  
articulation  
sphérique  
écrou  
Instruction manual  
manuel d’instructions  
manual de Instrucciones  
You can change the orientation of your showerhead by loosening nut  
and repositioning shower head; re-tighten nut. This allows for higher,  
lower or wider spray coverage.  
FloW ConTrol  
InSTAllATIon  
Have any questions or need assistance?  
Go to www.waterpik.com and click on Showerheads and  
click on the Ask Ann! link.  
®
®
Waterpik showerheads are equipped with an OptiFLOW regulator  
that limits maximum water flow to 2.5 gallons per minute at 80 psi  
as mandated by U.S. federal law.  
Aucun outillage n’est nécessaire.  
Enlever la vieille pomme de douche. Nettoyer parfaitement le filetage du  
tuyau. Visser à la main l’articulation sphérique sur le tuyau. Pour aligner  
l’unité avec le conduit de douche, desserrer l’écrou et repositionner la  
pomme de douche. Resserrer l’écrou.  
In the U.S., call our toll-free  
Outside the U.S.  
Customer Assistance Line,  
1-800-525-2774  
In areas with extremely low water pressure,  
causing the shower water flow to be  
unsatisfactory, the flow regulator may  
be removed to improve the water  
flow in the showerhead. To remove,  
unscrew filter screen by turning  
counterclockwise. Remove regulator  
with needle-nose pliers and replace  
filter screen.  
write us at:  
Water Pik, Inc.  
1730 East Prospect Road  
Fort Collins, CO  
U.S.A. 80553-0001  
In Canada, call our toll-free  
Customer Assistance Line,  
1-888-226-3042  
Patents pending.  
Spray change  
button  
If product malfunctions or becomes damaged, stop use and contact Water Pik, Inc.  
for replacement and/or repair.  
Waterpik®, Waterpik® (stylized) and OptiFLOW® are registered trademarks of Water  
Pik, Inc. AquaScape™ is a trademark of Water Pik, Inc.  
tuyau  
Washer  
Flow  
©2006 Water Pik, Inc.  
Regulator  
CAre And CleAnIng  
Remove showerhead from pipe. Then, remove filter screen with  
pliers by turning counterclockwise. Clean filter screen at least  
once a year, or whenever you notice a drop in water pressure. After  
cleaning, reinsert the filter screen and ensure that the washer is in  
place before reinstalling the showerhead.  
US Office:  
1730 East Prospect Road  
Fort Collins, CO 80553-0001  
U.S.A.  
articulation  
sphérique  
écrou  
Filter  
Screen  
Pivot Ball  
Nut  
Cleaning is required when mineral deposits appear on the spray  
orifices to maintain proper working conditions. Clean by soaking in  
household vinegar.  
Form No. 20008990-F AC  
Designed in U.S.A.  
Made in China.  
Do not clean or rinse any part with harsh chemicals, heavy duty  
cleaners, or abrasives; this may damage parts or finish and may  
void warranty.  
 

Technicolor Thomson Portable DVD Player DTH8657E User Manual
Teledyne Doll 200AU User Manual
Telenetics Network Card MIU56 User Manual
Terraillon Pedicure Spa IPX4 User Manual
Timex Watch 660 095000 User Manual
Toshiba Car Stereo System BDX1200KY User Manual
Toshiba Microcassette Recorder IK C44H User Manual
Toshiba Security Camera NVR16 X User Manual
Troy Bilt Yard Vacuum 24B 060F063 User Manual
ViewSonic Digital Photo Frame VFM153611 User Manual